tgrowl

joined 1 year ago
[–] tgrowl@lemmy.world 2 points 9 months ago

I’m still TS10 EDC all the way. Interested to see what recommendations you get here as I may look to change soon as well.

[–] tgrowl@lemmy.world 1 points 9 months ago

I’ve had way too much fun with these Gollum prompts…

 

“Gollum MotoGP racer”

[–] tgrowl@lemmy.world 1 points 11 months ago (1 children)

So I think I'm running into this problem a bit now. The reverse proxy and everything TCP and HTTPS works. The mail server I'm still trying to figure out. I'm using Wireguard to tunnel, do you know how to "bridge" that up to the VPS so that ports I need open to listen for incoming SMTP are also being listened on on the VPS?

[–] tgrowl@lemmy.world 2 points 11 months ago

This is the solution I went with. Had to tinker a bit with the KeepAlive settings, but otherwise smooth sailing now! Thanks!

 

Hi All,

Xpost from c/networking@lemmy.world

So since Reddit is out for me, I’m turning here to see if anyone has some insight or can comment on this. Anything you’ve got would be great!

Long and short, I made a quick decision and am now living in a “Spectrum Community” - whereby tenants are charged a fixed rate for Internet and TV and connect to a “mesh” network via captive portal where MAC addresses must be registered to the tennants. Everyone shares the same network, sorta, but it’s got that feature where no one can sniff each other (unless MAC addresses are registered to your name).

There’s some debate on posts regarding this, whether connecting your own gateway will cause an issue, but I would like to connect my own gateway / router. Now, I’d also like to port forward, as I run my own mail server, etc… which need this and a public IP address I can register with my domain in order for all the fun stuff to work.

I doubt I can connect the gateway / router and port forward as if the community were offering a “communal modem”, so the question becomes:

Can I defeat this “double NAT” by routing all traffic from MY gateway through a VPS? Then, can I tie my domain / proxy service to the public IP address of this VPS to make all my services work?

Other services I run: PiHole Unbound DNS resolving Emby Wireguard (for mobile access to PiHole) And other web based services

Again, thanks. Hopefully someone reads this and knows what I’m talking about. I believe in Lemmy.

 

skol!

 

This is my indoor hang setup during the winter. Just a small fleece blanket suspended from either end. I use a small tie in the middle to bundle up the ends of the blanket to create an air pocket. One one side i have a bungee cord to pick up slack and stretch out a bit for my feet.