Im working with an old reprap cotroled directly with an Laptop with cura. Filament is RS-Pro (2325395) Pla though. Open around 4 weeks ago but i have this problem in some capacity since i have this Filament. Before i had some really old pla which snapped all the time because it wss so brittle. Is this really just shitty Filament? Help/ Insight would be much appreciated.
Edit: solved. Disabling the retraction worked (as a temporary fix). The Spring of my extruder is too strong so my extruder was eating my filament especially in high retraction areas. The results with my old and hard filament were better because it was so hard the extruder didn't eat it. Picture is in the comments. Thanks everyone for your help.
depending on the situation, you can pull humidity back out of it and reuse it using a bunch of silica dessicant.
Or just toss it in the oven at a low temp for an hour or so. I've also turn my bed temp up high and put a spool on it with a box over it. Just cut some small holes in the too to allow humid air to come out. After an hour or so should be good to go. Assuming the issue is moist filament.
I misread this as you have a heater in your bed (the one you sleep in) and you dry your filament in bed.