Here's my 3D printed mini network rack.
It uses a TP-LINK TL-SG108 switch, a DIY patch panel, and a Raspberry Pi running PiHole. Here's the stl files if you would like to 3D print one yourself.
this post was submitted on 20 Jun 2023
16 points (100.0% liked)
homelab
6602 readers
1 users here now
founded 4 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
It's a bit of a mix. Most of the frame is PLA, while the green bits are PETG.
It's been going for well over a year now, and have not seen any warping thankfully.