139
Cisco Catalyst 2960-24TT-L
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 13 Dec 2023
139 points (100.0% liked)
196
15695 readers
1 users here now
Be sure to follow the rule before you head out.
Rule: You must post before you leave.
founded 1 year ago
MODERATORS
Hmm. I planned to upgrade it to newest available IOS for this device, 15.0.2-SE11.
What kind of bricking are we talking about here? (Permanent or fixable)
I only found this:
Which should be fixed, and if not, I could just downgrade it back. Worst case scenario: I'll have to use xmodem instead of TFTP.
I can't remember the exact message, basically when we upgraded about 10 of ours, they wouldn't let us make any config changes past a certain point because they saw themselves as non genuine even though they are we've recently replaced all of our switching, I'll boot one of them up once I get in and check for you (+IOS version)
Do you remember if you could get to a rommon prompt? As long as console access is available you should've been able to upload replacement FW. I once had to use kermit or xmodem (I don't recall) @2400 bps to recover an AP by transferring new FW over the console cable (I'm not sure new APs even have a console port), but switches should be recoverable...the things you do, when you want to go home and not spend another day on site 🤣
My only caution would be to ensure that you use the correct FW. IIRC -L means Lan Base not IP Services, but it should warn you that there isn't enough space, if that's the case