Been daily driving low-profile Gateron switches for a while but wanted to give MX another shot. Mostly so I can use my nice keycaps again. I didn't buy this filament specifically for this build but I think it works really nicely.
Switches are Ergo Clears, lubed and filmed with (IIRC) 45g springs. They were previously on an Ergodox and barely got any use as I switched to smaller boards shortly after modding them and wasn't comfortable with desoldering yet, so I'm happy to have finally found a new home for them.
Caps are MT3 Godspeed, case is Overture Matte PLA (light blue and white), printed on the Sovol SV06 Plus.
How do you find the trackball in the middle? I've been trying something similar by putting one between my split but I find it to be a pain. Maybe it's better integrated?
I've only been using it for a day so I'm still figuring that out. Something about it feels a bit 'off' compared to my Elecom Deft Pro but I'm not sure if that's a hardware or software issue - could just be a smaller ball is harder to get the same accuracy, could be the cheap BTUs I'm using. I'll probably try printing a different trackball holder that uses static bearings to see if I prefer that.