Home Automation

2951 readers

1 users here now

Discussion about general home automation ideas and projects, home automation protocols like Z-wave, Zigbee, Matter, etc, and home automation software and hubs like HomeSeer, Home Assistant, OpenHAB, Homey.

founded 1 year ago

MODERATORS

Moskus@lemmy.world

Make an DIY and FOSS Garage door opener in West europe... (iusearchlinux.fyi)

submitted 7 months ago by Stevenson@iusearchlinux.fyi to c/homeautomation@lemmy.world

4 comments fedilink hide all child comments

cross-posted from: https://iusearchlinux.fyi/post/5789452

Hi all,

I would like to install a door opener on my single panel jamb garage door

So for starter it seem hard to find brands that sell engine and accessory available for west europe.... (so, if you have any, fell free to share.)

My garage will be access by few peoples. therefore they need to have access but without being able to add or remove any other access..

So to start an external keypad might do.. and the engine should not have button that allow programming..

In the future I would like to be able to (trough Internet)

open/close the door remotely

add/remove code on the keypad

add/remove remote control that are bind with the door.

I've found all-in-one solution but they are of course not FOSS[^foss]..
So no thank you ! I would like to be able to connect easily a SBC or SBM[^1][^2]

So if you have any clue or if you think of a Lemmy community that might fit this post, I'm all ears.

Thanks.

[^1]: Single-Board Computer [^2]: Single-board microcontroller [^foss]: FOSS aka FLOSS

you are viewing a single comment's thread
view the rest of the comments

[–] CameronDev@programming.dev 1 points 7 months ago

Thats basically what i was thinking, but I dunno if that counts as FOSS in the OP eyes. The hardware is probably not open.

Definitely the way to go though, and what I would do.