this post was submitted on 20 May 2024
676 points (98.3% liked)

Cool Guides

4655 readers
1 users here now

Rules for Posting Guides on Our Community

1. Defining a Guide Guides are comprehensive reference materials, how-tos, or comparison tables. A guide must be well-organized both in content and layout. Information should be easily accessible without unnecessary navigation. Guides can include flowcharts, step-by-step instructions, or visual references that compare different elements side by side.

2. Infographic Guidelines Infographics are permitted if they are educational and informative. They should aim to convey complex information visually and clearly. However, infographics that primarily serve as visual essays without structured guidance will be subject to removal.

3. Grey Area Moderators may use discretion when deciding to remove posts. If in doubt, message us or use downvotes for content you find inappropriate.

4. Source Attribution If you know the original source of a guide, share it in the comments to credit the creators.

5. Diverse Content To keep our community engaging, avoid saturating the feed with similar topics. Excessive posts on a single topic may be moderated to maintain diversity.

6. Verify in Comments Always check the comments for additional insights or corrections. Moderators rely on community expertise for accuracy.

Community Guidelines

By following these rules, we can maintain a diverse and informative community. If you have any questions or concerns, feel free to reach out to the moderators. Thank you for contributing responsibly!

founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
[–] jet@hackertalks.com 11 points 5 months ago* (last edited 5 months ago) (1 children)

Check the documentation for your soldering station, if your soldering station doesn't have any documentation you can go with the melting point of the solder itself plus some overhead.

But as illustrated below, it can get a little complicated, if you're doing a lot of soldering with the same solder you'll experiment and figure out what's good for you

Ideally you want to use the lowest temperature you can get away with, using too much temperature can potentially shorten the lifespan of your soldering tips, and potentially damage the printed circuit board.

Get a testing board, any old board will do, and do some soldering and desoldering at different temperatures.

https://kb.hakkousa.com/KnowledgebaseArticle10297.aspx

lets look at the melting points of common solders:

  • Tin/Lead (Sn63/Pb37) - 183°C
  • SAC 305 (Sn/Ag3.0/Cu0.5) - 220°C
  • SN100 (Sn) - 232°C

Now let's add the 50°C we need for making a good soldering connection:

  • Tin/Lead: 183°C + 50°C = 233°C
  • SAC 305: 220°C + 50°C = 270°C
  • SN100: 232°C + 50°C = 282°C

We now need to consider the type of soldering station we are using......Soldering Station which has very good performance, we should add approximately 100°C as the heat reserve for quick thermal recovery.  The resulting temperature settings are:

  • Tin/Lead: 233°C + 100°C = 333°C
  • SAC 305: 270°C + 100°C = 370°C
  • SN100:  282°C + 100°C = 382°C
[–] capnminus@lemmy.world 6 points 5 months ago (1 children)

350°C has been my sweet spot with my hakko soldering station

[–] bloodfart@lemmy.ml 1 points 5 months ago

the 888 dial set to 12-o-clock or one-o-clock lol