"You need to buy this special heater pad to break the screen adhesive!"
No, I think you will find that in fact I don't.
this post was submitted on 09 Jun 2024
291 points (98.0% liked)
3DPrinting
15344 readers
136 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Doesn't that require a much higher temperature than most beds would be able to safely achieve.
I had to take the screen off of a Pixel not terribly long ago to replace the battery. I used a heat gun and I remember it requiring a temperature of like... 240C° or some such? And when I'm printing PLA, my printer bed only gets to 60C°. (Not saying it couldn't go higher, but 240C° seems way higher than 60C°.)
No, that temperature would damage your screen. The professional hot plates for phone repair are typically set to 85-90°C. With a heat gun you may need to set a higher temperature since you are only heating up part of the phone and it cools down again during the process. My printer (Prusa MK3) with PCB heater can go up to 120°C, so it looks perfect for the job.
A heat gun is enough to melt through plastic, there is no need for higher temperatures. You can do it with a hairdryer.