this post was submitted on 27 Apr 2024
27 points (93.5% liked)

PC Master Race

14955 readers
1 users here now

A community for PC Master Race.

Rules:

  1. No bigotry: Including racism, sexism, homophobia, transphobia, or xenophobia. Code of Conduct.
  2. Be respectful. Everyone should feel welcome here.
  3. No NSFW content.
  4. No Ads / Spamming.
  5. Be thoughtful and helpful: even with ‘stupid’ questions. The world won’t be made better or worse by snarky comments schooling naive newcomers on Lemmy.

Notes:

founded 1 year ago
MODERATORS
 

The "startup repair" Macrium offers is garbage and won't even load, so while I have all my data, I don't have an OS...

I appreciate any insights!

top 6 comments
sorted by: hot top controversial new old
[–] Nollij@sopuli.xyz 10 points 6 months ago (1 children)

You can pretty easily create the extra partitions yourself (Google for "diskpart UEFI"). Not sure if that will put it in your UEFI boot list, though. It seems you'll also need to do some stuff with bcdedit, which is included in WinPE.

Good luck!

[–] Speculater@lemmy.world 4 points 6 months ago

After spending 16 hours on this, I'm going with a clean install on the new drive and manually saving what I can.

[–] Vilian@lemmy.ca 6 points 6 months ago (1 children)

windows starput is so garbage that i needed to fix it installing installing this on a pendrive and booting from there https://www.system-rescue.org/

[–] Speculater@lemmy.world 4 points 6 months ago

Thanks, I'll flash this with my laptop. I made a Windows Recovery Disk, but apparently that's worthless. My options are to attempt a repair or turn off the PC... Like you said, the attempt was hot garbage.

I wish Macrium wasn't so highly regarded, I would have attempted this with another route. Live and learn I guess. It took four days to copy the data, it corrupted the source, and the trial key they give you doesn't allow access to their support forums.

[–] edgemaster72@lemmy.world 4 points 6 months ago* (last edited 6 months ago) (1 children)

It's a bit of a long shot, but I recently had a similar issue that kind of resolved itself. I cloned from one SSD to another and it wouldn't boot, tried pretty much all the recovery options but wasn't getting anywhere. The drive I cloned had both W10 and 11 on it.

I set up a Windows 10 installer USB, booted from that, and for some reason the W11 partition gave me an option for a system restore point that wasn't available when previously booting from the SSD. It did its thing and after that I was able to boot into both W11 and then following that, W10.

Don't know if that helps you at this point but either way I wish you luck.

[–] Speculater@lemmy.world 3 points 6 months ago

Thanks for the tip, may help in the future. The failing drive was failing so quickly that I just went with a fresh install on the new one to get what I could and trash it. SSD is barely a year old too, never going with Kingston again.