Grippler

Haven't really used a mocha pot before, so I'm experimenting a little to find the right grind settings and ratios for my taste. Normally brew espresso on a flair classic. Went with this more modern design from bialetti because it also works on induction stoves.

Jeg har lige smidt graphene OS på min pixel 8a, og havde egentlig lidt en forventning om, at det ville virke bedre end min gamle med lineage OS, når nu telefonen kan lave fuldt verified boot, med en bruger med play services installeret og den ikke er rootet...men ak nej, det er noget værre bøvl og det fejler i sidste del af verificeringen.

Kan det overhovedet lade sig gøre uden alle mulige træls krumspring som magisk osv?

Is there a slicer that let's you configure sections of the model to print at a different layer height?

I often have some larger models I'm printing, and 0.3mm layers are just fine for this to speed things up, but some of the overhangs print very poorly with thick layers and require thinner layers to print well.

I recently made the switch from the marlin-based stock firmware on my anycubic kobra 2, to klipper. I didn't have issues with bed levelling or first layer on the stock firmware, but I'm having significant issues running klipper. The bed is uneven, the probed mesh shows a deviation of 0.197mm, it was the same when running stock FW+octoprint.

But it seemed to be correcting just fine for this on the stock FW. I got a consistent decent first layer across the entire bed.

With klipper, it's absolutely impossible to get it to correct for this unevenness. Half the bed will get perfect first layer, but then the second half is either way too squished or hardly connecting to the bed. And it's causing further issues as it's also hitting the print when moving, despite having Z-hop of 0.3mm for travel moves.

What the hell is going on? How do I fix this?

I have this incredibly loud noise coming from my Y-axis. It doesn't affect print quality, but it is horrible to listen to and really loud. It is present when the Y-axis moves at ~100mm/s and gets worse/louder as speed increases.

How can I mitigate this? There doesn't seem to be any mechanical issues when I move the bed by hand, it is smooth and easy to move.

Jeg skal finde et godt sted at spise en god burger og drikke nogle øl og drinks, men alle steder jeg finder kan man umiddelbart ikke bestille bord ved, eller også er det kontakt via SoMe (dem har jeg ikke).

Har i nogle anbefalinger? Kvalitet over kvantitet