Teaching by example!
atest123
joined 1 year ago
Lovely!
I think pictures of said cat would be greatly appreciated 😉
In space, yesterday's coffee is tomorrow's coffee
Oof! That’s rough. With a full shop you Could build it from scratch in half the time. Can’t beat the price, though…
You can double up the handles, which also spreads the load a bit so they don’t cut into your hand as much. It is mainly for compactness and easy marketing
Guaranteed to last a lifetime, for sure!
Pretty straightforward leaves some room for ambiguity. You’re a pion until you decide you aren’t
The rivaling hamburger mobile. Just didn’t catch on
It might be an issue with concentricity. If the nozzle is not perfectly centered it creates a step that the filament can snag on. It can then cause the already softened filament to bunch up during deretraction forming a plug in the heat break. I had this issue with cheap nozzles. Everything starts fine and after a few layers it all stops for apparently no reason. Cranking up the heat makes it better for a bit, before making it worse
Witty one-liner
view more: next ›
The new scrum master is working hard