Woodworking

6827 readers

66 users here now

A handmade home for woodworkers and admirers of woodworkers. Our community icon is submitted by @1985MustangCobra@lemmy.ca whose father was inspired to start woodworking by Norm and the New Yankee Workshop.

founded 2 years ago

MODERATORS

NataliePortland@lemmy.ca

Building an adjustable router dado jig! (nkorai.com)

submitted 1 week ago by nkorai@reddthat.com to c/woodworking@lemmy.ca

4 comments fedilink hide all child comments

I made this satisfying clickity clackity jig for a future project - it was a blast to make and try out! If you want to read more about it, follow the link and consider subscribing :)

you are viewing a single comment's thread
view the rest of the comments

[–] HewlettHackard@lemmy.ca 2 points 3 days ago (1 children)

Can you elaborate on this a bit?

[–] NataliePortland@lemmy.ca 2 points 3 days ago* (last edited 3 days ago) (1 children)

Okay I have the jig clamped to a board here. I use a bit with a 3/4” diameter. If I run it down the length of this jig it will cut a 3/4” dado. So to make the jig I glued a piece of 1/4” plywood onto a wider piece of 1/4” plywood. Then I used a 3/4” router bit to cut through the wider piece by running it against the glued on upper piece.

So wherever I clamp this jig is exactly where my 3/4” dado will go

Here is the circular saw jig that is made and used the same way

Did I explain it well?

[–] HewlettHackard@lemmy.ca 2 points 1 day ago

Yes, thanks! I have clamped one piece to guide my router before, but using two would be much easier since it eliminates the need to measure the offset to the “far” stop every time. Clever!