Found this in the cyberpunk subreddit in a post from 2 years ago with people complaining that people were over-reacting and it's 'just a camera on legs that will never be weaponized'. Cue San Francisco want to weaponize one a year later, also apparently Dallas used their bomb disabling robot to kill a sniper in 2016.
Here's some totally random paperwork on Spot's network setup! https://support.bostondynamics.com/s/article/Spot-network-setup
It should be noted that some versions of spot have both 5ghz and 2.4ghz wifi but should still be vulnerable to deauth attacks. Upon losing network connection for more than a few seconds the robot should sit down and turn off the motors. However, they do make an LTE capable version. :this-is-fine:
EMP generators are fairly easy to make
And super overkill
maybe it’s overkill for spot, but they’re really versatile and can be used to disable many of the state’s tools of oppression
Anything of a decent power at a reasonable size though? I know about those little spark-gap based units, but you gotta be right up on the electronics for them to work. Only other stuff I'm familiar with was some rather large stuff that I think they demoed at defcon some years back.
Spark gap transmitters are kinda jank. They emit noise across the entire radio spectrum, interfere with everything, and will draw the ire of the FCC. Probably one of the few things they will actually look into if it becomes an ongoing problem. Spark gap transmitters are extremely inefficient. Only a very tiny fraction of the power will be converted into RF at the correct frequency to interfere with the target. They are very easy to make, however. Literally, build a circuit which makes sparks - mission accomplished. Just don't electrocute yourself. Turn on an AM radio in the middle of the thunderstorm sometime, and you can observe this phenomenon yourself (don't walk around outdoors with an antenna in an electrical storm like an idiot though).
A much more effective device would specifically target the frequencies in use, putting all of its power into that bandwidth instead of wasting it jamming airplanes, satellites, broadcasts, and cell phones as well. This can be enhanced with a directional antenna like a dish or a yagi to increase the gain (stronger signal with same wattage) and mitigate some collateral damage. This type of device should only be used momentarily (i.e. temporarily disabling a drone). Anything permanent will be detected and investigated, as well as anything temporary which is actually leading to drone kills.
Modern radio systems built using spread spectrum technology are much more resilient against jamming. I do not know enough radio stuff to really know a good way to counter them. Due to their military applications, there is definitely a lot of research going into constructing them and jamming them however. It surely will be a lot more work than desoldering a resistor from a yaesu, plugging in the frequency and CTCSS tone for the municipal cops' analog FM repeater, and sharing your favorite N.W.A. songs with them.
If the bad frequency is not known, It is possible to investigate spectrum usage in your area using something like a RTLSDR (a USB software defined radio receiver). A RTLSDR combined with a directional antenna can be used to pinpoint what direction which signals are coming from. Different chips may be needed to operate at different frequency ranges. An ordinary RTLSDR (originally based on USB VHF/UHF TV tuner cards) won't be able to operate on the 2.4ghz and 5.0ghz bands. There are other chips which can do this. With radio equipment in general, there is no one size fits all. Radios either handle one job well, or several jobs kind of shitty.
Every now and then, amateur radio operators set up "Foxhunting" events, where contestants use radio equipment to hunt down the location of a hidden transmitter. You can find a lot of useful information about the techniques employed to do this (and perhaps, how to counter them) by searching for ham literature about foxhunting.
Totally unrelated, but the other day I rewatched Pump Up the Volume for the first time in like 30 years and it held up surprisingly well.
you just need a large enough power source and coil. you can make the coil urself and use a car battery for power
Idk if a car battery is a reasonably size though. Also I threw all mine in the ocean.
:rat-salute-2: thank your for your service