144
I finished my 3D Printable screw design! Excellent print ability, reliable for simple use, though the head is prone to strip... can't win them all.
(programming.dev)
If you wanna print it yourself, the model is here: https://www.printables.com/model/1348194-4n-threaded-flat-head-screws-and-nuts-10-32-equiva
Design to be a drop in replacement for 10-32 screws with a much, much higher pitch. These screws are extremely easy to print, is reliable enough that it can hold some weight.
If you wanna print this yourself, you need to make sure that the screw is sideways, so if it breaks it's no on the layer lines.
Using them in my own prints which had metal screws and they are holding quiet well.
Just an FYI if you're not familiar with American screw sizes, calling this a 10-32 equivalent is probably going to confuse come people.
The naming convention used for screws in America includes the shank diameter and the pitch of the thread in threads per inch (TPI)
So a 10-32 in a #10 diameter screw with 32 threads per inch
Below about ¼ inch diameter, the American system usually uses that numbered system, a #10 screw is .190 inches or roughly 3/16
For larger diameter screws they usually just use the nearest fractional equivalent instead of the screw number, so a ¼-20 is roughly ¼ inch (actually .242in/ or #14) diameter and has 20 TPI
Most sizes have a standard coarse and fine thread, for #10 32TPI is the fine thread, and 20TPI is the coarse thread
Little back-of-the-envelope math that I'm not super confident in, this would be something like a 10-16 screw. You might want to rename it or add a note to that effect, or maybe call it something like a #10 extra coarse thread.
I don't know much, other than I have a box of them at home which I used for my older designs, and kept with since I could buy them cheap enough in bulk.
Wanted to make them out of plastic because I wanted to save some costs and this is what I got. I also find it funny that I got the thread which has a 15.875TPI at the end of the day. Half of what I am use to.