homeassistant

11998 readers

93 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 1 year ago

MODERATORS

GreatAlbatross@feddit.uk

ESPHome advanced troubleshooting (lemm.ee)

submitted 9 months ago* (last edited 9 months ago) by aniki@lemm.ee to c/homeassistant@lemmy.world

9 comments fedilink hide all child comments

I started mucking about with ESPHome yesterday and setup a WROOM with an AHT22 temp/humidity sensor. Running the wizard and adding the configs is easy-peasy. I started to have issues as soon as I wanted to flash.

If the AHT22 is plugged in, I cannot flash the device over USB.
I can check the serial logs once the device is flashed and then plug in the AHT22 once the device is booted and get readings, but
Once I unplug the ESP32 from the serial port and plug it into a power supply, I got nothing. No network activity at all.
Unplug the AHT22, plug into the power source, wait a few seconds, plug in the AHT22 has seemed to work correctly this morning and HA is pulling data but I tried that last night a few times and it didn't work -- so unsure why it's working this morning other than strange timing when I'm plugging the thing back in.

I am using the basic esp32dev firmware, which I am assuming works because it DOES work, eventually, but I'm not confident I'm using the right base but I cannot figure out which one to use.

you are viewing a single comment's thread
view the rest of the comments

[–] sramder@lemmy.world 3 points 9 months ago

It might be a WiFi connection issue. My devices connect perfectly after I flash a new configuration, but my AP seems to reject the next few login attempts. They eventually connect, but it takes a few minutes.