this post was submitted on 02 Jul 2023
1 points (100.0% liked)

Microcontrollers

117 readers
2 users here now

Discussion about any and all microcontrollers. Arduino, ESP32, ESP8266, PIC, STM, whatever!

Hardware and software welcome.

You are welcome to show off your project here!

founded 1 year ago
MODERATORS
MrMonkey@lemm.ee
1
Write-only ATTINY programming through UPDI? (feddit.de)
submitted 1 year ago by baal@feddit.de to c/microcontrollers@lemm.ee
0 comments fedilink hide all child comments
 

I have a design that includes an ATTINY424 doing simple logic functions / I2C monitoring.

From my understanding UPDI is a half-duplex UART. For simple factory programming (no verification or debugging needed), do I need the RX side of the UART or can I just bit bang the programming sequence through a single open-drain I/O of another processor and ignore all responses? (Using an external FET to protect the processor from the possible 12V pulse of an external POD if I decide to use one at some time) Does anyone have experience with that?

Verification is not required since the functionality of the ATTINY will be fully covered by the HW test.

no comments (yet)
sorted by: hot top controversial new old
there doesn't seem to be anything here