this post was submitted on 06 Oct 2024
35 points (94.9% liked)
Asklemmy
43974 readers
699 users here now
A loosely moderated place to ask open-ended questions
If your post meets the following criteria, it's welcome here!
- Open-ended question
- Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
- Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
- Not ad nauseam inducing: please make sure it is a question that would be new to most members
- An actual topic of discussion
Looking for support?
Looking for a community?
- Lemmyverse: community search
- sub.rehab: maps old subreddits to fediverse options, marks official as such
- !lemmy411@lemmy.ca: a community for finding communities
~Icon~ ~by~ ~@Double_A@discuss.tchncs.de~
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Yeah that’ll be a replace of at least the cat now unfortunately.
If there was a stub you can re-clamp to it and check for leaks. If there isn’t one you’re good to go until it falls off again.
I was completely wrong when I looked yesterday. I don’t think it s as bad.
That's not a catalytic converter that's just a resonator (or possibly muffler) to set the exhaust tone. A cat is further up toward the engine and has O2 sensors before and after it. You can probably just clamp it for a while but the proper fix is to have a new resonator/muffler put in or have it cut out and replaced with a section of pipe.
You can probably weld or jerry rig this together with clamps in a pinch, but you should probably replace. Unfortunate it looks like Toyota designed it to be one pipe - sometimes these are separate pieces that are cheaper and easier to replace.
A piece of stainless steel or aluminum duct and a few hose clamps will hold this together long enough for you to forget that you rigged it when it breaks again and you actually have to replace something.
You might be able to get away with cutting out a section and clamping a new piece on.
If you do please check that there isn’t an exhaust leak.
That's well fixable. I got a stainless steel toilet brush holder and cut a cylinder out of it, cut it down lengthways and wrap it round, with some GunGum underneath. Four heavy duty jubilee clips to hold it in place.
Lasted for about 5 years on a MK5 Transit
Yeah thats broke
Either clean up and attempt to weld a sleeve or get a new exhaust from the cat back