this post was submitted on 25 Oct 2023
5 points (100.0% liked)

Ask Electronics

3311 readers
21 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 1 year ago
MODERATORS
DavideAndrea@discuss.tchncs.de
linker3000@discuss.tchncs.de
5
How to Dimension a Power Supply for an Audio Amplifier ? (discuss.tchncs.de)
submitted 1 year ago by megrania@discuss.tchncs.de to c/askelectronics@discuss.tchncs.de
7 comments fedilink hide all child comments
 

Hi,

I recently bought a few pre-made amplifier modules for an 8-channel amplifier project (for a sound installation).

The amp is based on the TDA7294 chip and is rated 85W nominal. Now I'm looking for a power supply, but I'm a bit lost (this isn't really my strongest field, to put it mildly).

Do I just need to add up the output power, 8*85W = 680W, or could I get away with using something smaller, like a 300W or 300VA?

Also, the seller said that you need to use CV power supplies, CC won't work and kill the circuit. Does that mean a switching supply can't be used?

It looks like the module has a rectifier and smoothing caps integrated, so I could potentially just use a transformer, right?

Best, N

you are viewing a single comment's thread
view the rest of the comments
[–] user134450@feddit.de 1 points 1 year ago* (last edited 1 year ago)

Acording to the datasheet the TDA7294 uses -V~s~ and +V~s~ in the block diagram so i would assume it is intended to be used with DC power. If the module is specced for use with AC as well as DC, then this just means what you already suspected: it has an integrated bridge rectifier and most likely some sort of low pass for the rectified power (read: a bunch of big capacitors).

You could just go with a big transformer core that powers them all at the same time; many commercial amps do that and it works fine in general, provided you have enough margin for power spikes and the modules will not influence each other when connected in parallel to power.

In my opinion using separate transformers would be paranoid but it would work of course.

Edit: dont forget that this thing will produce heat. If you really go with an 800W transformer then you have to be able to cool about 400W in the worst case (going by the data sheet power dissipation of the chip and assumed transformer + rectifier efficiency of 90%).