this post was submitted on 27 Dec 2023
9 points (100.0% liked)

Ask Electronics

3325 readers
1 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 1 year ago
MODERATORS
DavideAndrea@discuss.tchncs.de
linker3000@discuss.tchncs.de
9
MOSFET gate resistor (discuss.tchncs.de)
submitted 10 months ago by Rolive@discuss.tchncs.de to c/askelectronics@discuss.tchncs.de
4 comments fedilink hide all child comments
 

Since MOSFETs have a gate capacitance you'd want to limit the inrush of current from the output of a microcontroller to prevent it from getting damaged prematurely. That's what gate resistors are usually good for.

Another thing is that most MOSFETs don't fully activate with a gate voltage below 10V (n type) so usually a microcontroller pin isn't good enough for switching large loads.

I have a 24V system and have made a voltage divider using two 10k resistors to step down 24V to 12V as gate driving voltage which is pulled down with a weaker MOSFET. The power MOSFET essentially ends up with a 10k gate resistor this way meaning it will take a bit longer to fully saturate.

Is too high harmful? In this situation the load is a heater that activates when the room temperature drops below 18C and deactivates when it gets above 22C so fast switching is not an issue.

you are viewing a single comment's thread
view the rest of the comments
[–] ignotum@lemmy.world 4 points 10 months ago

As long as it fully saturates i thiink it's fine, i've personally only had issues with too slow switching when i switch the mosfet many times a second, or when i didn't give a high enough voltage to fully saturate it, both of which usually led to a smoky mosfet