I replaced this battery last fall, but it has drained over the winter. The auto-mower dock wont charge it. Is there any feasible way to charge it safely? Or is it dead at that voltage? It’s a Bosch Indego 400. Thanks in advance.
this post was submitted on 02 Apr 2025
31 points (100.0% liked)
Ask Electronics
3596 readers
1 users here now
For questions about component-level electronic circuits, tools and equipment.
Rules
1: Be nice.
2: Be on-topic (eg: Electronic, not electrical).
3: No commercial stuff, buying, selling or valuations.
4: Be safe.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
In most cases of a dead battery it is just a lack of the circuit topology needed.
The thing is that the cells inside the pack have differences in resistance and this can drain the pack over time. That said, a cell can go bad and short circuit with a low resistance that will heat up massively and cause a fire if you are not careful.
If the ideal circuit topology were used, each cell would be individually controlled by the battery management chip. A less ideal situation is for each cell to have a thermistor, aka a low resolution temperature sensor to monitor each cell. Even less ideal, the batman needs at least one thermistor to monitor charging and ensure things do not get out of hand. The worst kinds of batman rely solely on the charge circuit topology to „safely” charge the pack.
The actual circuit topology for most lithium cells requires three different modes of operations. There is 1) initial trickle charging, 2) constant current mode, and 3) constant voltage mode.
If your battery does not charge, there are likely one of two reasons why. It could be well monitored and the batman has detected an over temperature anomaly in a cell or a short circuit in part of the pack. The second potential scenario is that the batman circuit is missing the trickle charge topology and there is a threshold pack voltage that must be met before the constant current mode can activate. If the cell has sat for a long period of time without charging, the second scenario is more likely, (but not guaranteed to the extent you should ever leave such a charging cell unattended for any amount of time).