this post was submitted on 10 Jun 2023
35 points (100.0% liked)
Technology
37712 readers
470 users here now
A nice place to discuss rumors, happenings, innovations, and challenges in the technology sphere. We also welcome discussions on the intersections of technology and society. If it’s technological news or discussion of technology, it probably belongs here.
Remember the overriding ethos on Beehaw: Be(e) Nice. Each user you encounter here is a person, and should be treated with kindness (even if they’re wrong, or use a Linux distro you don’t like). Personal attacks will not be tolerated.
Subcommunities on Beehaw:
This community's icon was made by Aaron Schneider, under the CC-BY-NC-SA 4.0 license.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I'm a DevOps Engineer and thus, I spend 8+ hours at a keyboard a day... I finally decided that I should spend some money on a device i was going to use that much of my life and I now have two Iris's I built. I'm using one to write this that I made last year so i could leave the one I built back in 2019 at the office. Both were v2's. I can't recommend them enough. Takes a little getting used to as you'll want to figure out your layers and play with QMK for things like adding a numpad under a layer and adding in special keys and macro's and such, but It's been well worth it. My wrist pain completely went away. Between that and either logitech trackball, It's been a great setup for 4yrs now and I can't go back to normal keyboards for any decent amount of time before starting to feel sore. FWIW, the new Iris Rev 7's make it so there's almost no soldering or anything.
My setup is Tented as well, and I made matching wrist wrests to match the contour and tenting angles.
Technical Details:
I used my original Iris for 3 yrs before deciding I should use what I had laying around to make this one. I bought two sets of PCB's when I originally got the v2's as it was my first mechanical keyboard build and I didn't want to worry about screwing it up. But I didn't have any issues, so I had another set of PCBs laying around that whole time. I decided for this one I'd go all out and make a custom bottom of walnut and I had laser cut brass top plates. I also used Millmax sockets for the keyswitches so they're hot-swappable. Then, since the v2's still require your to solder your own Arduino Pro Micro's, I swapped those out for nice!nano's so it's fully BlueTooth wireless both between the halves and to the PC. I've filled it with Hako Trues and MT3 White-on-Black doubleshot keycaps. So far, I'll say the True's are a bit stiff sometimes, but I still quite enjoy typing on this thing.